17-372 17-372
17. Backup and Restore
You can back up information in a robot controller to the computer.
You can also restore backup information saved to the computer back into a robot controller.
Backup
(Robot -> Personal computer)
Saves the backup data on the robot controller to the personal
computer.
Restore
(Personal computer -> Robot)
Transfers the backup data saved on the personal computer to the
robot controller.
In the RT ToolBox 3, you can back up the content that set in offline and you can restore the backup data to the
offline project.
For details, refer to the “17.3 Offline backup (Offline project -> PC)” and “17.4 Offline restore (PC -> Offline
project)”.
Offline backup
(Offline project -> Personal computer)
Save the contents that set in offline as backup data
to the personal computer.
Offline restore
(Personal computer -> Offline project)
Rewrite the offline project with the backup data
saved on the personal computer
.
Do not pull out the cable during communication.
Never pull out the cable during communication with the robot controller. If the communication
cable is removed during communication, the status of the robot controller or the personal computer
may be affected. Please remove the cable when the status is not “Online” or this software exited.
Also, do not pull out the USB cable when communicating by USB
until the communication is completed.
To Next Page
Loading...
