Mitsubishi Electric 3F-14C-WINE - Field Network Parameters; CC-Link Parameters

13-254 13-254
13.7. Field Network Parameters
13.7.1. CC-Link parameters
This sets the CC-Link information in the robot controller.
Set parameters while connected to the robot controller.
Double-click [Field network parameter] -> [CC-Link] under the [Parameter] item to be edited from the project tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
Figure 13-68 CC-Link parameter
You can reset CC-Link interface card errors by pressing the [Err. Cancel] button. After that the same error will not
occur. It is valid while the power supply of the Robot Controller is ON. When the power supply is turned OFF, the
error may occur again.
You can reference explanations of the displayed parameters by pressing the [Explain] button.
This function can only be used with CR800-D/CR750-D/CRnD-700/CRn-500 series robot controller.
Caution
CRn-500 series robot controller
CRnD-700 series robot controller