15-369 15-369
15.5.1. Register Password
The password is registered to the robot controller.
Click the "Register/Change" button of the item to which a password is to be registered in the "Password Setup"
screen. After inputting the password in the "Register/Change Password" screen, click the [OK] button. The input
password is displayed with "*" or "●".
Please input a password of 8 characters or more, and 32 characters or less. The characters that can be used are
as follows
Table 15-14 Character that can be used by password
Characters that can be used by passwords
(8 characters or more, and 32 characters or less)
Letters (from A to Z, and from a to z)
(Note) Upper case and lower case letters are
differentiated.
Figure 15-37 Register Password
Pay full attention to password management
It will be impossible to release the security function of the robot controller if the password is
forgotten. Pay sufficient attention to password management.
To Next Page
Loading...
