Mitsubishi Electric 3F-14C-WINE - Line Break after Insertion

11-136 11-136
3) Only for MELFA-BASIC V / MELFA-BASIC VI. When a program saved without line numbers format is copied to
a project other than the MELFA-BASIC V or MELFA-BASIC IV, the line number is automatically set.
4) Do not erase the tag indicating the command line / position variable. The program can not be read normally.
11.6.8. Line break after insertion
Wrap at the end of the command line when inserting the command template.
Figure 11-3 Wrap line when inserting the command template
The cursor moves to the next line
of the inserted command line
Insert template