Mitsubishi Electric 3F-14C-WINE - CC-Link IE Field Basic Parameters

13-256 13-256
13.7.3. CC-Link IE Field Basic parameters
This sets the CC-Link IE Field Basic information in the robot controller.
Set parameters while connected to the robot controller.
Double-click [Field network parameter] -> [CC-Link IE Field Basic] under the [Parameter] item to be edited from
the project tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
Figure 13-70 CC-Link IE Field Basic parameters
You can reference explanations of the displayed parameters by pressing the [Explain] button.
This function can only be used with CR800-D/CR800-R/CR800-Q series robot controller.
Caution