13-235 13-235
13.3.15. Collision avoidance parameters
You can set collision avoidance parameters in the PC and robot controllers.
For details of these parameters, refer to the robot controller's operations manual, See "Detailed explanations of
functions and operations".
13.3.15.1. Collision avoidance function parameter
Double-click [Movement parameter] -> [Collision avoidance] -> [Collision avoidance function] under the
[Parameter] item to be edited from the project tree.
You can set information related to the Collision avoidance function.
The controllers which can set the parameters [Collision avoidance function] are as follows.
Table 13-12 The controller and the robot model which can set the parameters [Collision avoidance function]
Software version of the robot controller
CR800-D(*1)/CR800-R/CR800-Q
(*1) You can't do the following operations.
・ Click the [Multiple CPU parameter screen] button
・ Set the common coordinates for collision avoidance
・ Click the [Apply from robot arrange of 3D monitor] button
・ Click the [Reflect to robot arrange of 3D monitor] button
Figure 13-36 Collision avoidance function parameter
Y
ou can switch the robot wi
th the combo box<a>.
After you change a parameter values, you can rewrite the parameter in the robot controller by clicking the [Write]
button.
You can show the “Multiple CPU parameter” screen by pressing the [Multiple CPU parameter screen] button.
(You can change the size of user setting area at the “Multiple CPU parameter” screen shown by the operation.)
You can set the coordinates in this screen from the 21 3D Monitor by pressing the [Apply from robot arrange of
3D monitor] button.
You can update the 21 3D Monitor from coordinates in this screen by pressing the [Reflect to robot arrange of 3D
monitor] button.
You can reference explanations of the displayed parameters by pressing the [Explain] button.
To Next Page
Loading...
