Mitsubishi Electric 3F-14C-WINE - Open the RT Toolbox2 Workspace; Closing a Workspace

8-75 8-75
8.4. Open the RT ToolBox2 Workspace
As with the “8.3Opening an Existing Workspace”,you can open the workspace of RT ToolBox2.
When RT ToolBox 2 workspace is opened with RT Toolbox 3, a dialog is displayed to confirm whether to use RT
Toolbox 2 parameters for the first time only.
Check the parameters to be used in RT Toolbox 3 and click the [OK] button.
RT ToolBox3 displays the following RT ToolBox2 parameter information.
Simulator parameters ⇒ Offline parameters
Offline parameters ⇒ Backup parameter information
Figure 8-6 Open the RT ToolBox2 Workspace
8.5. Closing a Workspace
To close a workspace currently being edited, click the [Home] tab -> [Workspace] group -> [Close] button on the
ribbon. Note that to delete a workspace, you must close it first.
[Open the RT ToolBox2 Workspace] is displayed only once
Displayed only when RT ToolBox2's workspace is opened for the first time in RT ToolBox3. The
unchecked parameter information in the checkbox will not be available in RT ToolBox3.
Caution