21-548 21-548
21.6.9. User-defined area
You can check the user-defined area in the 3D monitor.
Only numbers set with the user-defined area parameter are displayed at "Properties".
In the offline mode, [User-defined area] is not displayed.
When a number item is set to [True], the respective user-defined area is displayed.
Also, multiple user-defined areas can be displayed together by entering only the numbers of specific user-defined
areas to display in the format "[1; 2]" in [Display].
Figure 21-58 Displaying and Hiding User-defined Areas
To Next Page
Loading...
