11-151 11-151
11.7.4.10. Jump to label / procedure definition line
If you left-click while holding down the [Ctrl] key for the label name or the procedure name of the instruction editing
area, jump to the corresponding definition line.
The robot program language corresponding to this function is as follows.
Table 11-4 Job correspondence table for robot program language
○: Enable ×: Disable
Figure 11-47 Jump screen to label definition line
11.7.4.11. Partial writing
Writes the selected program lines to the robot controller.
This is handy for reflecting the contents of a partially revised program in the robot controller. But be careful, only the
selected part of the program is written.
Select the line to write to the robot controller, and click the [Edit] tab -> [Transmission] group -> [Partially] button on
the ribbon.
Check the contents to be written, and then click [Yes].
Figure 11-48 Partial Writing
To Next Page
Loading...
