11-159 11-159
11.7.4.20. Removing comments from all lines in the program
It is possible to remove comments from all lines in the program.
Click the [Edit] tab -> [Comment] group -> [Remove all] button on the ribbon.
All comments in the program are removed except "’" (single quotation) and "Rem" commands.
Figure 11-55 Removing comments from all lines in the program
Remove comments from all line
Removal process for special comment command "Rem"
A space delimiter must be inserted between the comment command “Rem” and the line
number or other command. In the case of a Robot Controller, it may judge the comment
command “Rem” as a comment without space delimiter. But this software judges the comment
command “Rem” to be a comment if “Rem” is delimited by a space.
If there is a character “Rem” in the command line, this software doesn’t remove the comment
content. After the processing, these command lines are displayed in the command editing screen.
Confirm the contents and remove the comment content in the screen. Select the displayed
command line and click the [Jump] button to jump to command line in the command editing
screen.
Figure 11-56 List of command line which includes “Rem” that cannot take as the comment
To Next Page
Loading...
