14-306 14-306
14.3.2.4. Named signal definition information reading
When you click the [Load] button, a message asking you to confirm that you want to delete a registered general
input/output signal is displayed.
This message asks you to confirm that you want to clear the current general input/output signal display.
Figure 14-33 Deletion Confirmation Message for Registered General Input/Output Signal
If you select [Yes] on this confirmation screen, the "Select locate" screen asking you to select the load source is
displayed.
Figure 14-34 Device Selection
Select the device to load from, and then click the [OK] button.
When PC is selected, the screen for selecting files on the PC is displayed.
To Next Page
Loading...
