17-376 17-376
(3) Specify the backup destination. The default value is the folder where the workspace was created/project
name/Backup/today's date and time.
You can change the backup destination folder with the […] button at the right of the displayed backup
destination.
You can also back up other items at the same time by putting checkmarks in their checkboxes. In this case, the
data is backed up to the selected backup destination, with the identifier added to the folder name according to
the backup type. The identifiers are as follows.
All…ALL Program information…PRG Parameter information…PRM System program…SYS
The folder name at this time is displayed on the right side of the respective backup items.
Figure 17-3 Backup (When Multiple Selected)
(4) Specify the back destination, then click the [OK] button. The confirmation screen is displayed. Confirm, then
click [Yes], to start backup.
Figure 17-4 Backup Confirmation Screen
When backup is completed, the backup data is displayed under [Backup] in the project tree.
Figure 17-5 Display of Backup Information
To Next Page
Loading...
