21-585 21-585
Also, models hose parts are displayed in 3D monitor as shown below, but does not check for hose part
interference, please note.
Figure 21-116 Models does not check for hose part interference
Perform the interference check with the 3D monitor displayed. The
interference check will not be executed if the 3D monitor display is
minimized.
During the interference check, robot movement on the 3D monitor
sometimes slows down. If this happens, either reduce the number of
objects set as targeted in the interference check or decrease the override.
On low-performance PCs, the interference check sometimes is not
performed normally.
To Next Page
Loading...
