4
SETUP AND PROCEDURES BEFORE OPERATION
4.2 Setup and Procedures before Operation
4 - 3
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES
BEFORE OPERATION
5
UTILITY PACKAGE
(GX CONFIGURATOR-
AD)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
4.2 Setup and Procedures before Operation
Start
Module mounting
Mount the A/D converter module in the specified slot.
Wiring
Wire external devices to the A/D converter module.
Intelligent function module switch settings
Use user range settings?
Offset/gain setting
Use the utility package?
Initial setting and auto refresh setting
Programming and debugging
Create and check the sequence program.
Use factory defaults
settings
Use user range settings
NO
YES
Perform settings using GX Developer
(Refer to Section 4.5).
If user range settings are used, perform the
offset and gain settings (Refer to Section 4.6).
The program can be simplified if the utility
package is used for setting (Refer to Chapter 5 ).
To Next Page
Loading...
Need help?
General
