Mitsubishi Electric GX Configurator-AD (SW2D5C-QADU-E) User Manual

3
SPECIFICATIONS
3.4 Buffer Memory
3.4.12 Warning output settings (Un\G48)
3 - 64
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND PROCEDURES BEFORE OPERATION
5
UTILITY PACKAGE (GX CONFIGURATOR- AD)
6
PROGRAMMING
7
ONLINE MODULE CHANGE
8
TROUBLESHOOTING
3.4.12 Warning output settings (Un\G48)
(1) This area is used to set whether the process alarm/rate alarm warning is to be output
or stopped on a channel basis.
(2) To validate the warning output setting, the operating condition setting request (Y9)
must be turned ON/OFF. (Refer to Section 3.3.2.)
(3) By default, all channels are set to disable.
[Setting example of Q68AD-G]
When process alarm warning output is enabled for channel 1 and rate alarm warning
output is enabled for channel 3, FBFE
H is stored into Un\G48.
[Setting example of Q66AD-DG]
When process alarm warning output is enabled for channel 2 and rate alarm warning
output is enabled for channel 4, 373D
H is stored into Un\G48.
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
CH4 CH3 CH2 CH1CH8 CH7 CH6 CH5CH4 CH3 CH2 CH1CH8 CH7 CH6 CH5
0: Enable, 1: Disable
For Q66AD-DG, information of b6, b7, b14, b15 is fixed at 0.
Un\G48
Rate alarm setting Process alarm setting
b15
CH4 CH3 CH2 CH1CH8 CH7 CH6 CH5CH4 CH3 CH2 CH1CH8 CH7 CH6 CH5
EBF
FBFE
H
1111101111111110
b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
F
b15
CH4 CH3 CH2 CH1CH6 CH5CH4 CH3 CH2 CH1CH6 CH5
D73
373D
H
0011011100111101
b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
3

Mitsubishi Electric GX Configurator-AD (SW2D5C-QADU-E) Specifications

General

Brand	Mitsubishi Electric
Model	GX Configurator-AD (SW2D5C-QADU-E)
Category	Control Unit
Language	English