Mitsubishi Electric GX Configurator-AD (SW2D5C-QADU-E) User Manual

5 - 30
5.8 Usage of FB
5.8.1 Outline
5
UTILITY PACKAGE (GX Configurator-AD)
5.8 Usage of FB
This section describes the procedure for using FB with GX Developer.
For details, refer to "GX Developer Version 8 Operating Manual (Function Block). "
5.8.1 Outline
The procedure for creating FB is shown below.
(1) Set up the intelligent function module parameter (initial setting/auto refresh
setting).
(2) Convert the intelligent function module parameter into FB.
(3) Paste the FB to a sequence program.
(4) Convert (compile) the sequence program.
Next, a flowchart of procedures 1) to 4) is shown below.
End
Convert (compile) the sequence program. Refer to sections 5.8.3.
4)
Paste the FB to a sequence program. Refer to sections 5.8.2.GX Developer
3)
Convert the parameter into FB. Refer to sections 5.7.
2)
Set up the initial setting/auto refresh setting. Refer to sections 5.4 and 5.5.GX Configurator-AD
1)
Start

Mitsubishi Electric GX Configurator-AD (SW2D5C-QADU-E) Specifications

General

Brand	Mitsubishi Electric
Model	GX Configurator-AD (SW2D5C-QADU-E)
Category	Control Unit
Language	English