1
OVERVIEW
1.1 Features
1 - 3
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES
BEFORE OPERATION
5
UTILITY PACKAGE
(GX CONFIGURATOR-
AD)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(11)Scaling function
A/D conversion values can be converted to percentage values (%) in the preset range
and be loaded into the buffer memory. This function can reduce the time required for
programming. (Refer to Section 3.2.6.)
(12)Online module change
Furthermore, the following operations can be processed by using sequence pro-
grams. (Note that these operations are possible for the modules of the same model
only.) (Refer to Chapter7.)
• Transferring the offset/gain set values to the replacement A/D converter module
• Transferring the offset/and gain set values to another A/D converter module
mounted on the other slot
(13)Offset/gain setting
GX Configurator-AD, dedicated instruction (G(P).OFFGAN) or mode switching setting
allows a shift to the offset/gain setting mode easily.
(14)Easy settings using GX Configurator-AD
Using GX Configurator-AD which is sold separately, sequence programs can be
reduced since settings of the A/D converter module can be made on the window.
Also, the set status or operating status of the module can be checked easily.
A FB
*1
can be created automatically from the set intelligent function module parame-
ter, and can be used in sequence programs.
*1 FB is the function for making a circuit block used in a sequence program repeatedly a part (FB) to
use it in the sequence program.
This function can improve the efficiency of program development and minimize program bugs to
improve program qualities.
For the details of FB, refer to "GX Developer Version 8 Operating Manual (Function
Block)."
To Next Page
Loading...
Need help?
General
