Mitsubishi Electric GX Configurator-AD (SW2D5C-QADU-E) User Manual

3
SPECIFICATIONS
3.2 Function List
3.2.4 Warning output function
3 - 26
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND PROCEDURES BEFORE OPERATION
5
UTILITY PACKAGE (GX CONFIGURATOR- AD)
6
PROGRAMMING
7
ONLINE MODULE CHANGE
8
TROUBLESHOOTING
(2) Rate alarm
(a) If the range of change in the digital output value sampled at intervals of the rate
alarm warning detection period is equal to or greater than the rate alarm upper
limit value or is equal to or less than the rate alarm lower limit value, the warning
output flag (rate alarm) (Un\G51) and warning output signal (X8) turn ON and the
ALM LED is lit to indicate the warning of the rate alarm.
(b) If, after the output of the warning, the rate fell below the rate alarm upper limit
value or rose above the rate alarm lower limit value and returned to within the set-
ting range, "0" is stored into the bit position corresponding to the channel
number of the warning output flag (rate alarm) (Un\G51).
The warning output signal (X8) turns OFF only when all channels return to within
the setting range.
Time
Rate alarm
warning detection
period
Varying rate (%) of
digital output value
Time
Rate alarm
warning detection
period
Rate alarm
upper limit
value
Varying rate of
CH1 digital
output value
Rate alarm
lower limit
value
Varying rate of
CH2 digital
output value
Digital output value
CH1 digital
output value
CH2 digital
output value
CH1 rate alarm upper limit value
(Un\G51.b0)
CH1 rate alarm lower limit value
(Un\G51.b1)
CH2 rate alarm lower limit value
(Un\G51.b2)
Warning output signal (X8)

Mitsubishi Electric GX Configurator-AD (SW2D5C-QADU-E) Specifications

General

Brand	Mitsubishi Electric
Model	GX Configurator-AD (SW2D5C-QADU-E)
Category	Control Unit
Language	English