171
WT07627X03
7-3-2. Night Mode (quiet operation) Schedule
Outdoor units can be operated in a quiet mode for the specified time period. Use the Night mode when low-noise
operation of the outdoor unit is preferable during the night.
Click [Functions 2] in the menu bar, and then click [Night Mode Schedule] to access the Night Mode Schedule
settings screen.
Note: Make the Night Mode Schedule settings only when all the units are in normal operation. When connection error occurs with
the indoor or the outdoor units, the target outdoor units may not be displayed properly.
Note: The degree of noise reduction depends on the outdoor unit model.
Note: The Night Mode Schedule settings may not be accessible if logged in as a building manager.
(1) In the [Start Time] and [End Time] sections, specify the start and end times for the Night mode.
Note: When the start time and the end time is the same, the units will operate in the Night mode at all times.
Note: The time period over the next day (such as 22: 00 - 6: 00) can be set.
(2) In the [Target Outdoor Units] section, select the M-NET addresses of the target outdoor units.
(3) Click [Save Settings] to save the settings.
Start Time
Target Outdoor Units
Refresh
Click to import the settings
from AE-200/AE-50/EW-50.
End Time
Save Settings
Click to save the changes
made.
To Next Page
Loading...
Need help?
General
