33
WT07627X03
5-1-3. Date and time
Touch [Initial Settings] in the menu bar, and then touch [Date and time].
Set the current date and time, and then touch [Save Settings].
Note: The date and time settings may not be accessible if logged in as a building manager.
Note: The date and time settings made on this screen will be reflected on all the units in the M-NET system, all connected
AE-50/EW-50 units, and the AE-200 units whose [Time Master/Sub] setting is set to [Sub].
Note: The date and time cannot be set on this screen if the [Time Master/Sub] setting is set to [Sub].
Note: The daylight saving time setting is required only on the AE-200.
Note: The date and time settings made on the AE-50/EW-50 unit whose [Time Master/Sub] setting is set to [Sub] will not be sent to
the other AE-50/EW-50 units.
Note: If the current time is moved forward while the scheduled operation is performed, the operation that was scheduled to take
place during the time that was skipped will not be performed.
Note: Changing the date and/or time when the charging function is in use can affect the calculation of the charges.
Note: If the system is connected to a TG-2000A, make or change the settings from the TG-2000A.
Note: When AE-50/EW-50 controller, DIDO controller (PAC-YG66DCA), AI controller (PAC-YG63MCA), or PI controller (PAC-
YG60MCA) is added to the system, set the current date and time on this screen to synchronize the date and time on the
added controller.
Note: Although date and time settings can be made on each AE-50/EW-50, the date and time synchronization from AE-200 is
performed once a day. Make the date and time settings on the AE-50/EW-50 only after the AE-50/EW-50 is replaced.
Important
● When one or more AE-50/EW-50 controllers are connected, the date and time settings must be made with the AE-50/EW-50
properly connected to ensure proper settings.
(1) Set the current date and time.
(2) To automatically adjust the daylight saving time, touch the “Daylight saving time” button. Touch the applicable
country, and then touch [OK].
Note: When not using the daylight saving time function, touch “----.”
Note: If the applicable country is not found, touch [Custom settings] at the bottom, and touch [OK]. Then, touch [Edit] to open
the screen below, and manually configure the daylight saving time setting.
Current date and time
Set the current date and
time.
Daylight saving time
Touch to set the country
to automatically adjust the
daylight saving time.
Edit
Touch to manually configure
the daylight saving time
setting.
Save Settings
Touch to save the changes
made.
To Next Page
Loading...
Need help?
General
