183
WT07627X03
8. Maintenance
This section explains backup and reading of settings data.
There are two ways to backup the settings data — from the AE-200’s LCD to a USB memory device, and from
AE-200/AE-50/EW-50 Web Browser for Initial Settings.
8-1. Settings Data Backup from the AE-200’s LCD
Backup the settings data from the AE-200’s LCD to a USB memory device.
Backup of settings for the AE-200 and for the expansion controller is possible.
Note: Test the USB memory device several times before use and verify that the device functions properly. Reading data from or
writing data to a USB memory device that has not been confirmed to work may cause unexpected problems. (If the data
cannot be output to the USB memory device after a writing error occurs and the device is replaced, reboot the AE-200/AE-50
(turn off the power and restart). Do not use the USB memory device that has experienced writing error once.)
8-1-1. Backing up settings data
The settings data can be exported to a USB memory as a backup.
Touch [Maintenance] in the menu bar, and then touch [Backup].
Note: IP address settings will not be backed up. Make sure to write them down.
Important
● The USB memory device may not be recognized if you insert and remove it within a short time. If this happens, reset the
AE-200/AE-50.
● The AE-50/EW-50 data can be output from the AE-200.
(1) Remove the controller cover, and insert a USB memory device to the USB port.
All settings
Copy to USB Memory
Touch to back up the
settings data.
To Next Page
Loading...
Need help?
General
