6
- 73
6.13 Execution Time Measurement
6.13.1 Program list monitor
6
FUNCTIONS
(3) Startup program
Note6.28
Note28
Program can be started on the program list monitor screen.
Clicking the button displays the following dialog box.
(a) Program name
Select the program set in the program setting of the PLC parameter dialog box.
A program name cannot be entered as desired.
(b) Startup mode
The stand-by type program can be changed to "Scan execution", "Low speed
execution"
Note6.29
or "Fixed scan execution".
The value set in the program setting of the PLC parameter dialog box is displayed
as the default value of fixed scan execution. ms or scan be selected as the
unit.Note29
Note28
Diagram 6.44 Startup program screen
Note29
Basic
Note6.28
In the case of Basic model QCPU, a program cannot be started from the program list monitor
screen.
Basic
Note6.28
Startup program
(b)
(a)
Redundant
Note6.29
Since the Redundant CPU cannot use low speed execution type programs, "Low speed
execution" cannot be selected in the start mode.
Redundant
Note6.29
To Next Page
Loading...
