119/128
Backing up and Restoring
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Notes
After installation and initial setup, the batteries of the MX-DoorMaster should be charged
continuously for the first 12 hours. This takes place automatically via the PoE-powered
T25 door station using the MxBus two-wire cable.
During this time, the electrical door opening function should not
be used (except for functional testing). This will maximize and
extend the battery life of the high-quality NiMH batteries (industry
standard) to several years at normal use.
When a battery has been completely drained, a functional test
can only be carried out after the red LED has turned o (after
approx. 15 minutes).
When replacing the batteries, always be sure to use original batteries. You can purchase
these directly from MOBOTIX or your MOBOTIX partner.
6.2.5 Exchanging an Info Module
The door station remains operational despite the Info Module
malfunctioning or being exchanged. Because of this, you do
not need to run a system restore after exchanging it.
Proceed as Follows:
1. Disconnect the door station from the power supply (for example, remove the net
-
work plug).
2. Remove the defective Info Module from the module frame as described in the
T25-System Manual Part 1
,
Section 2.4.7, «Removing, Exchanging and Modifying
Modules»
.
3. Exchange the Info Module. Take care not to damage the cabling or mix up the con
-
nections. The connection diagrams are provided in the
T25-System Manual Part 1
.
4. Power up the system again. After an automatic reboot, the door station is ready
for operation again.
To Next Page
Loading...
