104/128
T25 System Manual Part 2: System Expansion with MxEasy
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
5.2 Integrating the Door Station into a Network with Static IP
Addresses
If there is no DHCP server in the network or this is not to be used, all network devices
must have a static IP address in the same address range to be able to communicate with
one another. This also applies to the T25 and its remote stations, which are to be newly
integrated into the network (LAN – Local Area Network). You have to know the IP addresses
and subnet mask currently in use on the network.
A computer that is already configured to work on the network is necessary for configuration.
The MOBOTIX software MxEasy must be installed on this computer (free to download from
www.mobotix.com> Support).
Note
For Steps 4 and 5 described here, which must be carried out with MxEasy, please also
refer to the
«Integrating an IP Video Door Station»
section in the MxEasy manual (free
to download from www.mobotix.com> Support> Manuals).
Configuration Comprises the Following Steps:
• Integrate T25 including remote stations into network
• Assign static IP addresses to video phones (on the video phone)
• Assign static IP address to operation computer (on computer)
• Assign static IP address to T25 (with MxEasy)
• Further configure T25 and initiate Auto Configuration (with MxEasy)
• Set up Super PIN and admin card (on KeypadRFID)
Step1: Integrate T25 Including Remote Stations Into Network
Connect (one or more) T25, the video phones being used and, if not already done, a com
-
puter with the router/switch into the network. Each T25 must have a (PoE) power supply.
Step2: Assign Static IP Addresses to Video Phones (at the Video Phone)
Please note: The following settings refer to the menu of the Grandstream GXV3140 video
phone. The settings must be made in the relevant menus for IP video phones from other
manufacturers.
When first operating the video phone, we recommend configuring the desired Menu
language on the display first:
• Menu> Personalize> Language> Select Language
To Next Page
Loading...
