Mobotix T25 - Adding Admin Cards

72/128
T25 System Manual Part 2: KeypadRFID Access Configuration
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
3.3.4 Adding Admin Cards
As part of the initial setup, you have already set up a red admin card via
the KeypadRFID (
Section 2.2.2 ). If needed, you can also set up additional
admin cards via the KeypadRFID (e.g., as backup cards or for other
users wanting to manage the system). Contact your MOBOTIX dealer
to purchase red admin cards.
To set up an additional red admin card, you need a previously set-up
admin card or the Super PIN. Proceed as follows:
Proceed as Follows:
1. Enter Configuration Mode: Press the OK/MENU button until you hear the second
beep (button flashes blue).
2. Hold your previously set-up admin card up to the KeypadRFID’s buttons (or enter
the Super PIN and then press the OK/MENU button) until you hear a beep and the
OK/MENU button continuously lights up blue.
3. Enter Access Configuration Mode: Briefly press the blue key button, which then
lights up blue.
4. Enter Add Mode: Press the OK/MENU button until you hear the second beep (but
-
ton lights up blue).
5.
Hold up new admin card to be set up: Hold the new admin card up to the KeypadRFID
buttons until a beep sounds and the KeypadRFID shows a flashing ring pattern.
Make sure that the card does not touch and inadvertently trigger any of the buttons.
hold (2nd beep)
OK
hold (2nd beep)
OK