73/128
Managing Transponders
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
6. As soon as the flashing pattern stops, setup for the new admin card is finished. You
are now back in configuration mode (the OK/MENU button lights up blue). Press the
ESC/ALARM button to exit. After 60 seconds, the mode is exited automatically.
7.
To check the transponder number of the new admin card, hold it up to the KeypadRFID
and make a note of the number. Press the “2“ button (c = card) until you hear the
second beep and then hold the new admin card up to the KeypadRFID.
Note
In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay
of more than 60 seconds, a low warning tone is sounded and the system reverts to
the regular operating mode (all buttons light up white). If required, re-enter into Add
mode as described above.
3.3.5 Erasing Admin Cards
If you no longer require a previously set-up red admin card, or if the card is no longer
available (loss, theft), you should erase the card for security reasons.
To do so, you will need one previously set-up admin card (or Super PIN) and the transponder
number of the admin card to be erased, if you no longer have another admin card. If you
still have the card, you can erase it by holding it up to the KeypadRFID without requiring
a transponder number.
Proceed as Follows:
1. Ready the set-up admin card and the admin card to be erased or its transponder
number and the Super PIN.
2. Enter Configuration Mode: Press the OK/MENU button until you hear the second
beep (button flashes blue).
3. Hold a red admin card not to be erased up to the KeypadRFID buttons (or enter the
Super PIN and then press the OK/MENU button, if there is no remaining admin card)
until you hear a beep and the OK/MENU button continuously lights up blue.
ESC
hold (2nd beep)
OK
To Next Page
Loading...
