Mobotix T25 - Page 74

74/128
T25 System Manual Part 2: KeypadRFID Access Configuration
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
4. Enter Access Configuration Mode: Briefly press the blue key button, which then lights
up blue.
5. Enter Erase Mode: Press the ESC/ALARM button until you hear the second beep
(button lights up blue). You can now erase the admin card at hand (step 6), or if you
no longer have the admin card, use its transponder number to erase it (step7).
6. Erase current admin card: Hold the card to be erased up to the KeypadRFID until
you hear the first beep (the ESC/ALARM button lights up red) and pull the card away
again. Next, confirm the card by again holding it up to the KeypadRFID until you hear
a beep.
Erase non-present admin card: Enter the transponder number of the card to be
erased and press the ESC/ALARM button until you hear the second beep (ESC/
ALARM button flashes red). Re-enter the transponder number for confirmation and
press the ESC/ALARM button until you hear the second beep.
7. The admin card details have now been erased from the system and, if required, the
card can be set up afresh. You are now back in configuration mode (the OK/MENU
button lights up blue). Press the ESC/ALARM button to exit. After 60 seconds, the
mode is exited automatically.
Note
In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay
of more than 60 seconds, a low warning tone is sounded and the system reverts to
the regular operating mode (all buttons light up white). If required, re-enter into Erase
mode as described above.
ESC
hold (2nd beep)
0 9
Transponder No.
ESC
hold (2nd beep)
0 9
Transponder No.
ESC
hold (2nd beep)
ESC