78/128
T25 System Manual Part 2: KeypadRFID Access Configuration
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Note
In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay
of more than 60 seconds, a low warning tone is sounded and the system reverts to
the regular operating mode (all buttons light up white). If required, re-enter into Erase
mode as described above.
3.4.3 Changing PINs
You require the user’s old and new PINs to change an access PIN previously set up for a
user. The personal number of the user to whom the access PIN may have been assigned
during the original setup is not required.
Proceed as Follows:
1. Select the new access PIN and immediately make a note of it on your T25 Product
Pass (
Section 3.2.2
). The new access PIN also needs to have at least four and no
more than 16 digits, and it may not consist of zeros only.
2. Enter Configuration Mode: Press the OK/MENU button until you hear the second
beep (button flashes blue).
3. Hold your admin card up to the KeypadRFID buttons until you hear a beep and the
OK/MENU button lights up blue continuously.
4.
Enter Access Configuration Mode: Briefly press the blue key button, which then lights
up blue.
5. Enter old PIN: Enter the previous access PIN and briefly press the blue key button
(button flashes blue).
hold (2nd beep)
OK
0 9
To Next Page
Loading...
