79/128
Managing Access PINs
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
6. Enter new PIN: Enter the new access PIN and briefly press the blue key button (but-
ton flashes blue). Re-enter the new access PIN for confirmation and briefly press
the blue key button (button lights up blue). A beep sounds and the KeypadRFID
displays a flashing ring pattern.
7. The access PIN is changed. You are now back in configuration mode (the
OK/
MENU button
lights up blue). Press the
ESC/ALARM button
to exit. After 60 seconds,
the mode is exited automatically.
Notes
In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay
of more than 60 seconds, a low warning tone is sounded and the system reverts to
the regular operating mode (all buttons light up white). If required, re-enter into Add
mode as described above.
You require the old and new PINs as well as the user’s personal or contact number
to change an access PIN previously set up for a user.
0 9
Access PIN
0 9
Access PIN
ESC
To Next Page
Loading...
