Mobotix T25 - Erasing User Cards

68/128
T25 System Manual Part 2: KeypadRFID Access Configuration
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
3.3.2 Erasing User Cards
If you no longer require a previously set-up blue user card, if the card is no longer avail-
able (loss, theft), or if you want to set up the card afresh with individual numbers, e.g., for
a dierent user or voice mailbox, you should erase the card.
To do so, you will need the red admin card (or Super PIN) and the transponder number of
the user card to be erased, if you no longer have the card itself. If you still have the card,
you can erase it by holding it up to the KeypadRFID without requiring a transponder number.
Proceed as Follows:
1. Ready the admin card and the user card to be erased or its transponder number.
2. Enter Configuration Mode: Press the OK/MENU button until you hear the second
beep (button flashes blue).
3. Hold your admin card up to the KeypadRFID’s buttons (or enter the Super PIN and
then press the OK/MENU button) until you hear a beep and the OK/MENU button
continuously lights up blue.
4.
Enter Access Configuration Mode: Briefly press the blue key button, which then lights
up blue.
5. Enter Erase Mode: Press the ESC/ALARM button until you hear the second beep
(button lights up blue). You can now erase the user card (step 6), or if you do not
have the card, use its transponder number to erase it (step 7).
hold (2nd beep)
OK
ESC
hold (2nd beep)