Mobotix T25 - Page 71

71/128
Managing Transponders
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
To set up a time-restricted user card, you need the red admin card. Proceed as
follows:
1. Press the blue key button until you hear the second beep (button flashes blue).
2. Hold your admin card up to the KeypadRFID buttons until you hear a beep and the
blue key button lights up blue continuously.
3. Set the validity period (1–48 hours): Enter the desired validity period in hours via the
KeypadRFID: (min. 1, max. 48).
4. Present time-restricted user card: Hold the user card up to the KeypadRFID buttons
until a beep sounds and the KeypadRFID shows a flashing ring pattern.
5. The system then returns to regular operating mode and setup of the time-restricted
card is complete. The entered time span commences immediately; the card can be
used for keyless access until the end of the validity period.
Note
In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay
of more than 60 seconds, a low warning tone is sounded and the system immediately
reverts to the regular operating mode (all buttons light up white).
hold (2nd beep)
0 9
Access Time (h)