Mobotix T25 - Page 35

35/128
Step2: Set Up the KeypadRFID Access Module
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
for keyless access. Continue with the next section (see Section 2.2.3, «Adding User
Cards at the KeypadRFID Module»
.)
4. If you do not wish to set up any user cards now, press the ESC/ALARM button to
exit the Add mode or wait 30 seconds until this happens automatically. Proceed
to
Section 2.2.4, «Setting the Time Zone, Time and Date» ) or Section 2.4, «Step3:
Configure the System Using a Video Phone»
).
Notes
When you set up a card as part of an extended T25 scenario (see Section 1.2 ), you have
the option of assigning a custom Personal, Transponder and Contact No. For further
information, refer to
Chapter 3, «KeypadRFID Access Configuration» of this manual.
In case of a wrong entry or cancellation via the ESC/ALARM button, a low warning
tone is sounded and the system will revert to the original mode it was in after the Auto
Configuration (KeypadRFID number buttons will flash white). Enter the Super PIN again.