Mobotix T25 - Page 76

76/128
T25 System Manual Part 2: KeypadRFID Access Configuration
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
4. Enter Access Configuration Mode: Briefly press the blue key button, which then lights
up blue.
5. Enter Add Mode: Press the OK/MENU button until you hear the second beep (button
lights up blue).
6. Assign access PIN: Enter the personal number of the user to whom you wish to
assign the access PIN and press the OK/MENU button. Otherwise, you can skip this
step and continue with step 7.
7. Enter PIN: Enter the access PIN on the KeypadRFID and press the blue key button (which
then displays a blue flashing pattern). Re-enter the access PIN for confirmation and
press the blue key button. A beep sounds and the KeypadRFID displays a flashing ring
pattern.
8. Setup of the new access PIN is complete. You are now back in configuration mode
(the OK/MENU button lights up blue). Press the ESC/ALARM button to exit. After 60
seconds, the mode is exited automatically.
Note
In case of a wrong entry, cancellation of entry via the ESC/ALARM button, or a delay
of more than 60 seconds, a low warning tone is sounded and the system reverts to
the regular operating mode (all buttons light up white). If required, re-enter into Add
mode as described above.
hold (2nd beep)
OK
0 9
Person No.
OK
0 9
Access PIN
0 9
Access PIN
ESC