Mobotix T25 - Changing the Super PIN at the BellRFID

88/128
T25 System Manual Part 2: BellRFID Access Configuration
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
3. Now press and hold both the ESC and the OK buttons until the feedback LED starts
blinking blue.
4. Hold a trained admin card in front of the BellRFID module or enter the Super PIN and
press OK. The feedback LED lights up blue.
5. Press the key button of the keypad insert. The feedback LED starts flashing blue.
6. Press the ESC button of the keypad insert until the feedback LED starts blinking blue.
7. Enter the person number of the transponders you want to delete and press OK. The
feedback LED lights up blue.
8. Enter the person number again to acknowledge and press OK. The feedback LED
lights up green and then slowly fades out.
9. Disconnect the power supply of the door station, remove the keypad insert and slide
the bell buttons back into the module (see
Section 2.3.3, «Inserting the Function/Bell
Buttons»
).
/
,..
,..
,..
2
1