Table 3-2 Typical Safety Symbols
Symbol General Description
CAUTION
Caution
Failure to follow instructions may damage equipment.
Important
Indicates additional information or used as a reminder.
General Safety Symbols - continued
3.5 Wiring Check
CAUTION
System Mains Supply Wiring:
• Before connecting the system to a power supply, it is important to check
that the wiring between the system and the power supply has been
done correctly.
• Particular attention must be given to the current rating of the power
supply. For example, if a controller is rated at 63A, then the power
supply must also be rated at 63A.
• Check that the phases of power supply are wired correctly.
Controller to Mold Wiring:
• For separate power and thermocouple connections, ensure that the
power cables are never connected to the thermocouple connectors and
vice-versa.
• For mixed power and thermocouple connections, ensure that the power
and thermocouple connections have not been wired incorrectly.
Communications Interface and Control Sequence:
• It is the customer’s responsibility to verify functionality of any custom
machine interface at safe speeds, prior to operating equipment in the
production environment at full speed in automatic mode.
• It is the customer’s responsibility to verify all required motion sequences
are correct, prior to operating equipment in the production environment
at full speed in automatic mode.
• Switching the machinery into Auto mode without having veried the
control interlocks and motion sequence are correct, may cause damage
to machinery and / or equipment.
Failure to do wiring or connections properly will result in equipment failure.
CAUTION
The use of Mold-Masters standard connections can help to eliminate the
potential for wiring errors.
Mold-Masters Ltd. cannot be responsible for damage caused by customer
wiring and / or connection errors.
3-8
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SAFETY
MT Controller User Manual
To Next Page
Loading...
