5.1 Introduction
New MT Series controllers leave the factory with their default settings which are
shown in this table:
Table 5-1 Factory Settings
Zone Temperature 260ºC or 500ºF
Standby Level 100ºC or 180ºF
Boost Level 75ºC or 135ºF
Over temperature Range
10ºC or 18ºF
Under temperature Range
Ramp On
Auto-Man On
Extended Alarms for Manual,
Standby and Boost
O
This section of the manual has procedures to change default settings to your
preferred values and also how to save these new values.
It is possible to restore the default settings at any time.
See “Restore Factory Settings and Recalibration” on page 7-2.
5-2
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SETUP
MT Controller User Manual
To Next Page
Loading...
