Section 7 - Maintenance
WARNING
Ensure that you have fully read “Section 3 - Safety” before doing
maintenance procedures on the controller.
CAUTION
External cables should be checked to see that there has been no damage
to the exible conduit, plugs or sockets.
If the exible conduit has been damaged or if there are any exposed
conductors, it must be replaced.
CAUTION
7.1 Service and Repair The Controller
7.1.1 Replacement Parts
We do not expect that you will need to repair any controller parts at board
level, other than fuses. In the unlikely event of any board failure then we
provide repair and exchange facilities for all our customers. See “Section 2 -
Global Support” on page 2-1 for our facilities.
7.1.2 Cleaning and Inspection
Any excess dust that has entered into the cabinet may be removed with a
light brush and vacuum cleaner.
If the equipment is subject to vibration then we recommend that you use an
insulated screwdriver to check that no terminals have become loose.
7-1
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
MAINTENANCE
MT Controller User Manual
To Next Page
Loading...
