Mold-Masters TempMaster MT - Page 6

Section 5 - Setup ..............................................................5-1
5.1 Introduction .........................................................................................................5-2
5.2 Set Zone Numbering ..........................................................................................5-3
5.3 Set the Temperature Scale .................................................................................5-5
5.4 Change Zone PID Characteristics ......................................................................5-7
5.5 Set the Ramp Feature .......................................................................................5-9
5.6 Set Boost Value ................................................................................................5-11
5.7 Set Standby Value ............................................................................................5-13
5.8 Monitor Temperature Limits ..............................................................................5-15
5.8.1 Warning and Alarm Limits ........................................................................5-15
5.9 Set Ground Fault Detection ..............................................................................5-17
5.10 Set Mold Leak Detection ................................................................................5-19
5.11 Set Response to Thermocouple Failure .........................................................5-21
5.12 Restrict Access to Manual, Standby or Boost .................................................5-23
5.13 Extend Alarms for Manual, Standby or Boost Operation ................................5-25
5.14 Language ........................................................................................................5-27
5.15 Set the Required Zone Temperatures ............................................................5-28
Section 6 - Operation .......................................................6-1
6.1 Run Mode ...........................................................................................................6-1
6.2 OFF Mode (Single Zone) ....................................................................................6-2
6.3 O󰀨 Mode (Single Module) ...................................................................................6-2
6.4 Manual Mode ......................................................................................................6-3
6.5 Manual Mode - Power Level ...............................................................................6-4
6.6 Slave Mode .........................................................................................................6-5
6.7 Standby and Boost Mode ...................................................................................6-7
6.7.1 Standby – Whole Cabinet ..........................................................................6-7
6.7.2 Boost – Whole Cabinet ..............................................................................6-7
6.7.3 No Standby or Boost Option ......................................................................6-7
6.8 Standby Mode – Individual Zones ......................................................................6-8
6.9 Leaving Standby Mode .......................................................................................6-9
6.10 Boost Mode – Individual Zones ......................................................................6-10
6.11 Change Set Temperature (Auto or Manual) .................................................... 6-11
Section 7 - Maintenance...................................................7-1
7.1 Service and Repair The Controller .....................................................................7-1
7.1.1 Replacement Parts ....................................................................................7-1
7.1.2 Cleaning and Inspection ............................................................................7-1
7.2 Restore Factory Settings and Recalibration .......................................................7-2
7.2.1 Default Settings .........................................................................................7-3
7.2.2 Calibration Routine ....................................................................................7-3
7.2.3 Calibration Sequence ................................................................................7-3
7.2.4 M.Dis Option ..............................................................................................7-4
7.3 Fuses and Overcurrent Protection ......................................................................7-5
7.3.1 Fans ...........................................................................................................7-5
7.3.2 Controller Cards .........................................................................................7-6
7.3.3 Onboard Power Supply ..............................................................................7-6
7.3.4 Output Fuse Type: HRC High Speed .........................................................7-6
7.3.5 Input Fuse Type: Surface-Mount Quick-Blow ............................................7-6
vi
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
MT Controller User Manual