Mold-Masters TempMaster MT - Page 9

List of Figures
Figure 3-1 Injection molding machine hazard areas .................................................3-2
Figure 4-1 MT controller ...........................................................................................4-1
Figure 4-2 MT2 controller .........................................................................................4-1
Figure 4-3 MT Menu .................................................................................................4-7
Figure 4-4 MT2 Menu ...............................................................................................4-7
Figure 7-1 Fuse location on a controller card ...........................................................7-5
Figure 9-1 Connect the neutral - position shown by blue
arrow ...................................................................................................................9-2
Figure 9-2 Install the three way link ..........................................................................9-2
Figure 9-3 Remove the neutral wire - position shown by the
blue arrow ...........................................................................................................9-4
Figure 9-4 Install the three 2-way links .....................................................................9-4
Figure 9-5 HAN4A connector ....................................................................................9-5
Figure 9-6 Harting Han 10 A
®
insert for MT-02-02 ....................................................9-6
Figure 9-7 Harting Han 10 A
®
cut out dimensions ....................................................9-6
Figure 9-8 Harting Han 16 E
®
insert for MT-02-02 ....................................................9-7
Figure 9-9 Harting Han 16 E
®
cut out dimensions ....................................................9-7
Figure 9-10 Harting Han 10 E
®
insert for MT-02-02 .................................................9-8
Figure 9-11 Harting Han 10 E
®
cut out dimensions ..................................................9-8
Figure 9-12 Insert for MT-04-04 ................................................................................9-9
Figure 9-13 MT-04-04 cut out dimensions ................................................................9-9
Figure 9-14 Insert for MT-06-06 ..............................................................................9-10
Figure 9-15 MT-06-06 cut out dimensions ..............................................................9-10
Figure 9-16 Inserts for MT-12-12 and MT-18-xx ..................................................... 9-11
Figure 9-17 MT-12-12 AND MT-18-xx cut out dimensions -
UK and Europe .................................................................................................9-12
Figure 9-18 MT-12-12 and MT-18-xx inserts (Plug 1 and Plug 2) ..........................9-13
Figure 9-19 MT-12-12 AND MT-18-xx cut out dimensions -
North America ...................................................................................................9-14
ix
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
MT Controller User Manual