Profile Configuration
7-41
Figure 7-23 Security NAT Pool screen
7. If adding a new NAT policy or editing the configuration of an existing policy, define the following
parameters:
8. Select the + Add Row button as needed to append additional rows to the IP Address Range table.
9. Select OK to save the changes made to the profile’s NAT Pool configuration. Select Reset to revert to
the last saved configuration.
10.Select the Static NAT tab.
The Source tab displays by default.
Name If adding a new NAT policy, provide a name to help distinguish it from others
with similar configurations. The length cannot exceed 64 characters.
Prefix Length Use the spinner control to set the netmask (between 1 - 30) of the network
the pool address belongs to.
IP Address Range Define a range of IP addresses that are hidden from the public Internet. NAT
modifies network address information in the defined IP range while in transit
across a traffic routing device. NAT only provides IP address translation and
does not provide a firewall. A branch deployment with NAT by itself will not
block traffic from being potentially routed through a NAT device.
Consequently, NAT should be deployed with a stateful firewall.
To Next Page
Loading...
