Profile Configuration
7-45
Figure 7-27 Dynamic NAT screen
18.Refer to the following to determine whether a new Dynamic NAT configuration requires creation, edit or
deletion:
19.Select Add to create a new Dynamic NAT configuration, Edit to modify an existing configuration or
Delete to permanently remove a configuration.
Source List ACL Lists an ACL name to define the packet selection criteria for the NAT
configuration. NAT is applied only on packets which match a rule defined
in the access-list. These addresses (once translated) are not exposed to the
outside world when the translation address is used to interact with the
remote destination.
Network Displays Inside or Outside NAT as the network direction for the dynamic
NAT configuration.
Interface Lists the VLAN (between 1 - 4094) used as the communication medium
between the source and destination points within the NAT configuration.
Overload Type Lists the Overload Type used with the listed IP ACL rule. Options include
NAT Pool, One Global Address and Interface IP Address. Interface IP
Address is the default setting.
NAT Pool Displays the name of an existing NAT pool used with the dynamic NAT
configuration.
Overload IP Enables the use of one global address for numerous local addresses.
To Next Page
Loading...
