Motorola Solutions AP-6511 Access Point System Reference Guide
7-46
Figure 7-28 Source ACL List screen
20.Set the following to define the Dynamic NAT configuration:
21.Select OK to save the changes made to the dynamic NAT configuration. Select Reset to revert to the
last saved configuration.
Source List ACL Use the drop-down menu to select an ACL name to define the packet
selection criteria for NAT. NAT is applied only on packets which match a
rule defined in the access-list. These addresses (once translated) will not
be exposed to the outside world when the translation address is used to
interact with the remote destination.
Network Select Inside or Outside NAT as the network direction for the dynamic NAT
configuration. Inside is the default setting.
Interface Use the drop-down menu to select the VLAN (between 1 - 4094) used as
the communication medium between the source and destination points
within the NAT configuration. Ensure the VLAN selected represents the
intended network traffic within the NAT supported configuration. VLAN1 is
available by default.
Overload Type Select the radio button of Overload Type used with the listed IP ACL rule.
Options include NAT Pool, One Global Address and Interface IP Address.
Interface IP Address is the default setting.
NAT Pool Provide the name of an existing NAT pool for use with the dynamic NAT
configuration.
Overload IP Enables the use of one global address for numerous local addresses.
To Next Page
Loading...
