Profile Configuration
7-51
7. Refer to the Management Policy field to select or set a management configuration for use with this
profile. A default management policy is also available if no existing policies are usable.
Use the drop-down menu to select an existing management policy to apply to this profile. If no
management policies exist meeting the data access requirements of this profile, select the Create icon
to access a series of screens used to define administration, access control and SNMP configurations.
Select an existing policy and select the Edit icon to modify the configuration of an existing management
policy. For more information, see Viewing Management Access Policies on page 10-2.
8. Refer to the Message Logging field to define how the profile logs system events. It’s important to log
individual events to discern an overall pattern that may be negatively impacting performance using the
configuration defined for this profile.
Enable Message
Logging
Select the radio button to enable the profile to log system events to a user
defined log file or a syslog server. Selecting this radio button enables the
rest of the parameters required to define the profile’s logging configuration.
This option is disabled by default.
Remote Logging Host Use this table to define numerical (non DNS) IP addresses for up to three
external resources where logged system events can be sent on behalf of
the profile. Select Clear as needed to remove an IP address.
Facility to Send Log
Messages
Use the drop-down menu to specify the server facility (if used) for the
profile event log transfer.
Syslog Logging Level Event severity coincides with the syslog logging level defined for the
profile. Assign a numeric identifier to log events based on criticality.
Severity levels include 0 - Emergency, 1 - Alert, 2 - Critical, 3 - Errors,
4 - Warning, 5 - Notice, 6 - Info and 7 - Debug. The default logging level is 4.
Console Logging Level Event severity coincides with the console logging level defined for the
profile. Assign a numeric identifier to log events based on criticality.
Severity levels include 0 - Emergency, 1 - Alert, 2 - Critical, 3 - Errors,
4 - Warning, 5 - Notice, 6 - Info and 7 - Debug. The default logging level is 4.
Buffered Logging Level Event severity coincides with the buffered logging level defined for the
profile. Assign a numeric identifier to log events based on criticality.
Severity levels include 0 - Emergency, 1 - Alert, 2 - Critical, 3 - Errors,
4 - Warning, 5 - Notice
, 6 - Info and 7 - Debug. The default logging level is 4.
Time to Aggregate
Repeated Messages
Define the interval (duration) system events are logged on behalf of this
profile. The shorter the interval, the sooner the event is logged. Either
define an interval in Seconds (0 - 60) or Minutes (0 -1). The default value is
0 seconds.
Forward Logs to
Controller
Select the checkbox to define a log level for forwarding event logs to the
control. Log levels include Emergency, Alert, Critical, Error, Warning,
Notice, Info and Debug. The default logging level is Error.
To Next Page
Loading...
