Motorola Solutions AP-6511 Access Point System Reference Guide
8-4
Figure 8-2 Wireless Firewall Policy Configuration screen
5. Refer to the Enable Firewall radio buttons to define the Firewall as either Enabled or Disabled. The
Firewall is enabled by default.
If disabling the Firewall, a confirmation prompt displays stating NAT, wireless hotspot, proxy ARP, deny-
static-wireless-client and deny-wireless-client sending not permitted traffic excessively will be disabled.
6. Refer to the General field to enable or disable the following Firewall configuration parameters:
Enable Proxy ARP Select the radio button to allow the Firewall Policy to use Proxy ARP
responses for this policy on behalf of another device. Proxy ARP allows the
Firewall to handle ARP routing requests for devices behind the Firewall.
This feature is enabled by default.
DHCP Broadcast to
Unicast
Select the radio button to enable the conversion of broadcast DHCP offers
to unicast. Converting DHCP broadcast traffic to unicast traffic can help
reduce network traffic loads.This feature is disabled by default.
L2 Stateful Packet
Inspection
Select the radio button to enable stateful packet inspection for routed
interfaces within the Layer 2 Firewall. This feature is disabled by default.
To Next Page
Loading...
