MUTOH ValueJet 1304 - Page 122

User’s Guide ValueJet 1304
Troubleshooting
122 AP-75780 - Revision 1.3
14 ** Press 2sec. **
Cleaning or Nozzle Check is
pressed for less than 2 seconds.
Press the key for more than 2
seconds again.
Operation
panel on
page19
15 Insert CleaningCart.
Washing the head.
Attach the cleaning cartridge.
Replacing
ink cassettes
on page30
16 Insert InkCartridges
Filling the ink.
Insert an ink cartridge.
Replacing
ink cassettes
on page30
17 Transport Mode
Preparing for transportation.
Please wait a while.
Transportin
g the printer
on page36
18 Media: Type ** OK? Initializing the media.
Please wait a while.
(** represents the setup media
type.)
MediaType
menu on
page63
19 Media Initial
20 Cover Open The front cover is open.
Installing
roll media
on page40
21 Lever Up
The media loading lever was
switched to the back side.
Set the media.
Installing
roll media
on page40
22 Manual Cut -> ENTER
Roll media is fed to the media
cut position after printing.
Press Enter after cutting media.
Cutting
media on
page91
Note
 If any message that is not in the table above is displayed on this product, there
is some operation malfunction.
 The value of the Authorization Code may be displayed for the display of the
option function.
For details, contact your local Mutoh dealer.
N° Display Remedy Reference