MUTOH ValueJet 1304 - Handling inks + waste

User’s Guide ValueJet 1304
Safety instructions
AP-75780 - Revision 1.3 13
1
1.3 Handling inks + waste
Before handling inks / cleaning fluids and their waste, please read the Material Safety
Data Sheets (MSDS) and the labels for important health, safety and environmental
information carefully. All safety data sheets are periodically updated. These sheets and
their translations can be found on www.Mutoh.eu
 Only use original manufacturer’s ink and appropriate cleaning liquid. Before installing an
ink holder, shake it gently. Doing so will preserve print quality.
 When ink is moved from a cold place to a warm place, keep the ink for three hours or more
in the new printing environment before printing.
 Do not disassemble ink holders. Otherwise, ink may get in your eyes or on your skin. A
disassembled ink holder can not be used either.
 When refilling ink, use original manufacturer’s ink. Our Mutoh printers are designed to use
original ink.
If you use ink which are not produced by the original manufacturer:
 Printing might become blurred and the end of the ink in the holder might not be
detected correctly.
 Any problems caused by using an ink holder other than those recommended above will
not be covered by the warranty, and repair expenses will be paid by the customer.
 For handling waste: refer to section 13 on the MSDS-sheet.
 Inks / Waste
 General advice: wear safety glasses and gloves especially when handling the waste
ink.
 After spill: remove contaminated clothing.
 After inhalation: if difficulties occur after vapour / aerosol has been inhaled, remove to
fresh air and seek medical attention.
 After skin contact: wash thoroughly with soap and water.
 After eye contact: wash affected eyes for at least 15 minutes under running water
while the eyelids are held open.
 After swallowing: rinse mouth and drink plenty of water. Never induce vomiting.
1.4 Warnings, cautions and notes
Safety terms in this manual and the contents of warning labels attached to the printer are
categorized into the following three types, depending on the degree of risc (or the scale of
accident).
Read the following explanations carefully and follow the instructions in this manual.
Safety terms Details
Important Must be followed carefully to avoid death or serious bodily injury.
Caution
Must be observed to avoid bodily injury (moderate or light) or damage to
your equipment.
Notes
Contains important information and useful tips on the operation of your
printer.