MUTOH ValueJet 1304 - Media Feed Compensation

User’s Guide ValueJet 1304
Handling the printer
46 AP-75780 - Revision 1.3
4.2.4 Media feed compensation
After every printed swat, the media is fed a certain distance. Depending on the kind of media
(weight, backing) another media feed compensation has to be set. This to avoid the following
phenomenon:
 Printed swats overlap
 White lines between every swat.
In such cases, follow the procedure below and adjust the media feed compensation value.
Step 1: Display the Media feed compensation menu.
 Press Menu
 “Menu1: Setup>] is displayed.
 The operation panel shifts to the Setup menu display.
 Press >.
 “Set1: MediaType” is displayed.
 Press ENTER.
 “Media: Type1” is displayed.
 Press + or - to select the media type to use.
 Press ENTER.
 “**>1: Print Mode” is displayed.
 Press + or - to select “**2: PF Adjust”.
 Press >.
 “PF1: Initial Print” is displayed.
 Proceed to Media feed compensation menu.