MUTOH ValueJet 1304 - Replacing Roll Media

User’s Guide ValueJet 1304
Handling the printer
50 AP-75780 - Revision 1.3
4.2.5 Replacing roll media
(1) Replacement time
Replace the roll media if...
...The roll media runs out
 The operation panel displays “End of roll”.
 If the media runs out during printing, the printer will stop operating.
...You want to change the media type.
(2) Replacement steps
To replace roll media, follow the procedure below. Note that the procedure consists of 2 parts.
Installing the new roll media
Caution
 Be careful that your fingers are not caught between the front cover and the
printer if you open or close the front cover.
Note
 For loading roll media, refer to Handling and installing media on page40.
 For roll media which you don’t use any longer, store it according to General info
on usable media on page39