MUTOH ValueJet 1304 - Adjust Print

User’s Guide ValueJet 1304
Handling the printer
AP-75780 - Revision 1.3 57
4
4.4 Adjust print
Used to align the print head.
Align the print head as described in the following procedure.
Step 1: Switch On the printer and load the roll media.
Step 2: Confirm that the printer functions normally.
Step 3: Display the printing mode menu.
 Press Menu.
 “Menu1:Setup>” is displayed.
 The operation panel shifts to the Setup menu display.
 Press >.
 "Set1: MediaType" is displayed.
 Press Enter.
 "Media: Type 1" is displayed.
 Press + or – to select the media type to use.
 Press Enter.
 "**>1: Print Mode" is displayed.
 Press Enter.
 "Mode: Graphics 2 – > " is displayed.
 The display shifts to the Printing mode menu.
Step 4: Select the printing mode that you want to use.
 Press + or – to select the printing mode to use.
 Press Cancel several times.
 The operation panel returns to Normal.
Note
 This printer has been adjusted for optimum print quality before shipment at the
Mutoh factory.
 Align the print head when the print quality decreases after the installation
environment or the media has been changed.