MUTOH ValueJet 1304 - Media Initial Menu; Media Width;Mediawidth Check Menu

User’s Guide ValueJet 1304
Handling the printer
76 AP-75780 - Revision 1.3
4.6.6 Media initial menu
Set up whether the media width and edge will be detected when initializing the media.
4.6.7 Media Width/MediaWidth check menu
If media detection is switched off, the media width menu allows you to manually enter the
media width.
Media width menu
Note
 When media initial menu is set to “OFF”, you can manually set the media width
in the media width menu.
Setup item Setting Description
Init.
OFF The media is not detected
Top&Width
Detect the media width and edge while
initializing the media
<Width>
Detect the media width while initializing the
media.
---
 ENTER: Saves the settings and shifts to
the previous hierarchy.
 cancel: cancels the settings and shifts to
the previous hierarchy.
Refer to:Panel Setup Menu on page62
Note
 Setting a larger value than the actual media width in the media width menu may
cause ink to be fired on the printer.
Setup item Setting Description
Media width
<1.00 mm> to 1351
mm
Sets the media width
---
 ENTER: Saves the settings and shifts to
the previous hierarchy.
 cancel: cancels the settings and shifts to
the previous hierarchy.
Refer to:User media menu on page63